推荐星级:
  • 1
  • 2
  • 3
  • 4
  • 5

基于串联反馈式稳压原理的程控电源设计

更新时间:2020-08-05 05:15:06 大小:232K 上传用户:守着阳光1985查看TA发布的资源 标签:稳压原理电源 下载积分:5分 评价赚积分 (如何评价?) 打赏 收藏 评论(0) 举报

资料介绍

目前大多数稳压电源都基于串联反馈式稳压原理来稳定电压,采用电位器调节反馈比例系数来改变输出电压,如果电位器频繁调节会造成电位器磨损,导致电压调整过程中出现跳点,影响电源的调节精度.夫兰克一赫兹实验中用于电子加速的电源,其最高电压约为90V左右,负载电流不超过1mA.如果直接采用串联反馈式基本电路,考虑到集成电路的最高工作电压,显然是不可行的.为此设计了一种改进的串联反馈式稳压电路,并且利用改变基准电源电压来改变输出电压,基准电源电压通过D/A转换电路得到,这样就可以实现程控电源.由于采用改变基准电源电压来改变输出电压,没有了电位器的使用,电位器磨损问题彻底解决,大大降低仪器的故障率.所研制的直流电源电压变化范围在10~100V,如果负载电流不超过1mA,误差在±1%以内.

Most of the current regulated power supplies are based on the principle of series feedback to stabilize voltage, and potentiometers are used to adjust the output voltage by changing its coefficient. The more potentiometer changes, the worst potentiometer will be caused, and jumping point in voltage adjustment process will influence adjusting accuracy of the power supply. Power supply for electron acceleration in Franck-Hertz experiment, whose highest voltage is about 90 V, the load current is less than 1 mA, which obviously can't use the series feedback type basic circuit , because the maximum working ...

部分文件列表

文件名 大小
基于串联反馈式稳压原理的程控电源设计.pdf 232K

【关注B站账户领20积分】

全部评论(0)

暂无评论

上传资源 上传优质资源有赏金

  • 打赏
  • 30日榜单

推荐下载