- 1
- 2
- 3
- 4
- 5
ServoOne安装调试手册
资料介绍
Note: Before commissioning the value of the connected mains voltage must be set in the servo controller(factory setting=3×400 V AC). More detailed information see chapter 4"Commissioning".
通讯接口
所有的Servo-One系列均有USB及TCP/IP通讯接口,可通过LT-I公司的Drive-Manager5软件进行通讯,进行相关参数的读写和现场调试,详情请参考章节.…
软件调试。
Servo-One Junior:X9(USB1.1)
TCP/IP(开发中)Servo-One:X2(USB1.1)
X3(TCP/IP)
Note: The faults can be acknowledged in accordance with their programmed reaction(ER) or reset via a 24 V-reset(X9/10)(ER.).
Attention: Faults marked with a dot can only be reset, after the cause of the fault has been eliminated.
显示为当前版本V5.4.0同时,相应的USB接口驱动也在对应的安装文件夹内,例:C:\Program FileLTI DRiVES GmbHILTi DriveManager 5.4.0drivers
部分文件列表
文件名 | 大小 |
ServoOne安装调试手册.pdf | 10M |
全部评论(1)
2021-10-14 08:03:06杨义
资料还行