- 1
- 2
- 3
- 4
- 5
基于Mk60N512VMD100的红外中继器设计
资料介绍
文章将红外收发模块连接到Mk60芯片上,使用稳压电路连接稳压芯片制造稳压电路。使用7.2V锂电池供电,经稳压电路转化为3.3V电压供入系统,驱动系统进入工作状态。采用NB1318型一体化红外接收头接收红外信号,接入处理电路将接收到的红外信号转化为信号,将电路接入Mk60的信号输入引脚,经过处理之后,通过引脚输出到输出模块。经过三极管9013和8050进行放大,驱动红外发射管发射出940nm的脉冲信号,完成红外中继。
In this paper,the infrared transceiver module is connected to the Mk60 chip,and a voltage stabilizing circuit is used to connect the voltage stabilizing chip to create a voltage stabilizing circuit.The lithium battery is supplied by 7.2 V,and is converted into 3.3 V voltage by the steady voltage circuit to supply the system.The driving system is in working state.The NB1318 type integrated infrared receiver receives the infrared signal.The access processing circuit converts the received infrared signal into the signal.The circuit is connected to the signal input pin of the Mk60.After processing,the circuit is output to the output module through the pin.After amplification by triode 9013 and 8050,the infrared transmitting tube is dr...
部分文件列表
| 文件名 | 大小 |
| 基于Mk60N512VMD100的红外中继器设计.pdf | 1M |
全部评论(0)