BS EN 61784-5-10-2008 工业通讯网络.剖面图.现场总线的安装.CPF 10用安

This International Standard is one of a series produced to facilitate the use of communication networks in industrial control systems. IEC 61918:2007 (Ed. 1.0) provides the common requirements for the installation of communication networks in industrial control systems. This installation profile standard provides the installation profiles of the communication profiles (CP) of a specific communication profile family (CPF) by stating which requirements of IEC 61918 fully apply and, where necessary, by supplementing, modifying, or replacing the other requirements (see Figure 1). For general background on fieldbuses, their profiles, and relationship between the installation profiles specified in this standard, see IEC/TR 61158-1. Each CP installation profile is specified in a separate annex of this standard. Each annex is structured exactly as the reference standard IEC 61918 for the benefit of the persons representing the roles in the fieldbus installation process as defined in IEC 61918 (planner, installer, verification personnel, validation personnel, maintenance personnel, administration personnel). By reading the installation profile in conjunction with IEC 61918, these persons immediately know which requirements are common for the installation of all CPs and which are modified or replaced. The conventions used to draft this standard are defined in Clause 5. The provision of the installation profiles in one standard for each CPF (e.g. IEC 61784-5-10 for CPF 10), allows readers to work with standards of a convenient size. 1 Scope This part of IEC 61784 specifies the installation profile for CPF 10 (Vnet/IP™1). The installation profile is specified in the annex. This annex is read in conjunction with IEC 61918:2007. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 61918:2007, Industrial communication networks – Installation of communication networks in industrial premises The normative references of IEC 61918:2007, Clause 2, apply. For profile specific normative references see Clauses A.2. 3 Terms, definitions and abbreviated terms For the purpose of this document, the terms, definitions and abbreviated terms of IEC 61918:2007, Clause 3, apply. For profile specific terms, definitions and abbreviated terms see Clauses A.3. 4 CPF 10: Overview of installation profiles CPF 10 consists of one communication profile as specified in IEC 61784-2. The installation requirements for CP 10/1 (Vnet/IP™) are specified in Annex A.