MSPM0L130x Mixed-Signal Microcontrollers datasheet

1 Features • Core – Arm® 32-bit Cortex®-M0+ CPU, frequency up to 32 MHz • Operating characteristics – Extended temperature: –40°C to 125°C – Wide supply voltage range: 1.62 V to 3.6 V • Memories – Up to 64KB of flash – Up to 4KB of SRAM • High-performance analog peripherals – One 12-bit 1.68-Msps analog-to-digital converter (ADC) with up to 10 total external channels – Configurable 1.4-V or 2.5-V internal ADC voltage reference (VREF) – Two zero-drift, zero-crossover chopper operational amplifiers (OPA) • 0.5-µV/°C drift with chopping • 6-pA input bias current 1 • Integrated programmable gain stage (1-32x) – One general-purpose amplifier (GPAMP) – One high-speed comparator (COMP) with 8-bit reference DAC • 32-ns propagation delay • Low power mode down to <1-µA – Programmable analog connections between ADC, OPAs, COMP, and DAC – Integrated temperature sensor • Optimized low-power modes – RUN: 71 µA/MHz (CoreMark) – STOP: 151 µA at 4 MHz and 44 µA at 32 kHz – STANDBY: 1.0 µA with 32-kHz 16-bit timer running, SRAM/registers fully retained, and 32MHz clock wakeup in 3.2µs – SHUTDOWN: 61 nA with IO wakeup capability • Intelligent digital peripherals – 3-channel DMA controller – 3-channel event fabric signaling system – Four 16-bit general-purpose timers, each with two capture/compare registers supporting lowpower operation in STANDBY mode, supporting a total of 8 PWM channels – Windowed watchdog timer • Enhanced communication interfaces – Two UART interfaces; one supports LIN, IrDA, DALI, Smart Card, Manchester and both support low-power operation in STANDBY – Two I2C interfaces; one supports FM+ (1 Mbit/s) and both support SMBus, PMBus, and wakeup from STOP – One SPI supports up to 16 Mbit/s • Clock system – Internal 4- to 32-MHz oscillator with ±1.2% accuracy (SYSOSC) – Internal 32-kHz low-frequency oscillator with ±3% accuracy (LFOSC) • Data integrity – Cyclic redundancy checker (CRC-16 or CRC-32) • Flexible I/O features – Up to 28 GPIOs – Two 5-V-tolerant open-drain IOs with fail-safe protection • Development support – 2-pin serial wire debug (SWD) • Package options – 32-pin VQFN (RHB) – 28-pin VSSOP (DGS) – 24-pin VQFN (RGE) – 20-pin VSSOP (DGS) – 16-pin SOT (DYY), WQFN (RTR)2 • Family members (also see Device Comparison) – MSPM0L13x3: 8KB of flash, 2KB of RAM – MSPM0L13x4: 16KB of flash, 2KB of RAM – MSPM0L13x5: 32KB of flash, 4KB of RAM – MSPM0L13x6: 64KB of flash, 4KB of RAM • Development kits and software (also see Tools and Software) – LP-MSPM0L1306 LaunchPad™ development kit – MSP Software Development Kit (SDK) 2 Applications • Battery charging and management • Power supplies and power delivery • Personal electronics • Building security and fire safety • Connected peripherals and printers • Grid infrastructure • Smart metering • Communication modules • Medical and healthcare • Lighting