- 1
- 2
- 3
- 4
- 5
电动汽车永磁无刷直流电机控制器设计
资料介绍
对某四轮独立驱动电动汽车轮毂电机进行研究,设计一种永磁无刷直流电机控制器.以STM32F103RBT6芯片为基础,对电机驱动电路、采样电路和保护电路分别进行硬件设计与分析;同时,采用模块化软件设计方案,对该控制器的软件系统进行升级.实验验证表明:所设计的电机控制器能使电机响应迅速、转速稳定、无超调,且电动车动力输出性能良好.
A permanent magnet brushless direct current motor controller was designed by studying the hub motor of a four-wheel independent drive electric vehicle.Based on STM32 F103RBT6 chip,the hardware design and analysis of motor drive circuit,sampling circuit and protection circuit were carried out respectively.At the same time,modular software design scheme was adopted to upgrade the software system of the controller.Experimental results show that the designed motor controller can ensure the motor fast response,stable speed,no overshoot,and good power output performances.
部分文件列表
文件名 | 大小 |
电动汽车永磁无刷直流电机控制器设计.pdf | 2M |
相关下载
- 华为模块电源管理设计指导-(V100R001_02 Chi...
- 华为LGA模块PCB设计指导_V2.0_20150126.pdf
- HUAWEI Module USB Interface Descriptor Gui...
- HUAWEI ME909s-821 LTE LGA模块硬件指南V100R...
- HUAWEI ME909s-821 LTE LGA Module Acceptanc...
- HUAWEI 30 mm x 30 mm LGA Module Hardware M...
- HUAWEI 30 mm x 30 mm LGA Module Developmen...
- Altium_Designer_规则设置三例.pdf
- STM32F407产品技术培训-DSP库及其例程
- STM32F407产品技术培训-2.浮点单元.pdf
全部评论(0)